Owners manual

WWW.BBKPERFORMANCE.COM
FOLLOW THESE INSTRUCTIONS CAREFULLY TO ENSURE CORRECT FITMENT AND OPERATION
UPDATED LAST: April 2018
27427 BOSTIK COURT
TEMECULA, CA 92590
For any questions, email us:
[e-mail]
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
MADE IN U.S.A.
STEP 7
Remove the (3) bolts that hold the heat shields to the exhaust manifold on the
driver and passenger side of the engine and remove the heat shields from the
vehicle.
STEP 8
Utilizing approved
jack and jack stands
or preferably a
vehicle hoist lift the
vehicle as high as
possible and secure
the vehicle properly.
Disconnect the (4)
oxygen sensor’s
from the wire
harness.
NOTE: on the (2) driver side oxygen sensor wiring harness you will need to
disconnect the wiring harness from the mounting point on the transmission.
On the one closest to the front of the vehicle you will need to cut the zip tie
from the connector which allows the wiring harness to stretch out and become
longer.
STEP 5
Disconnect the (2) rubber mounting straps that hold the sound tube to the strut
brace and A/C line located on the driver side of the engine. Below the A/C line
there is another vacuum line with a quick disconnect tting disconnect that
vacuum line and push it towards the re wall then toward the driver side inner
wheel well so that it is tucked out of the way.
STEP 6
Disconnect all of the spark plug wires and spark plugs from the engine on the
driver and passenger side of the engine.