Owners manual

ManualsBrandsBBK Performance ManualsAutomotive1930 Oil Separator Kit Fits 16-18 Camaro

WWW.BBKPERFORMANCE.COM

27427 BOSTIK COURT

TEMECULA, CA 92590

For any questions, email us:

tech@bbkperformance.com

INSTALLATION INSTRUCTIONS

INS260

2016-2018 CAMARO SS, 6.2L

OIL SEPARATOR KIT

Part # 1930

UPDATED LAST: June 2018

IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.

BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.

MADE IN U.S.A.

Diculty: Easy

Install Time: Approximately 1 hour.

No Special Tools required

Summary of content (3 pages)

PAGE 1
27427 BOSTIK COURT TEMECULA, CA 92590 For any questions, email us: tech@bbkperformance.com INSTALLATION INSTRUCTIONS INS260 2016-2018 CAMARO SS, 6.2L OIL SEPARATOR KIT Part # 1930 No Special Tools required Install Time: Approximately 1 hour. Difficulty: Easy MADE IN U.S.A. IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle. BBK Performance Inc.
PAGE 2
7427 BOSTIK COURT TEMECULA, CA 92590 For any questions, email us: tech@bbkperformance.com STEP 1 STEP 2 Remove factory PCV hose behind throttle body, now assemble oil separator kit as shown on front page. Make sure to hook up hose from the draw side of the oil separator to the intake manifold. STEP 3 (Note) Make sure to connect hose to intake as this the draw side of the oil separator kit. As shown in the picture the top hose is the draw side. MADE IN U.S.A.
PAGE 3
27427 BOSTIK COURT TEMECULA, CA 92590 For any questions, email us: tech@bbkperformance.com FOLLOW THESE INSTRUCTIONS CAREFULLY TO ENSURE CORRECT FITMENT AND OPERATION STEP 4 STEP 5 Remove factory strut tower bracket bolts then mount oil separator assembly, then run hoses forward and use supplied clamps at engine connection. Use 1/4 socket and ratchet to tighten clamps do not over tighten then use supplied zip tie for loose hoses as shown in picture.