Manual

ManualsBrandsBBK Performance ManualsCar18315

2010-2013 Ford F-150 Raptor SVT 6.2L V8

Cold Air Induction Kit

Part # 1831

INS-184

Special Tools

Required:

•

T-20 Torx

Install Time:

Approximately

1 Hour

Difficulty:

2 out of 5

Follow these instructions carefully to ensure correct fitment and operation.

STEP 1

STEP 3

• Disconnect the Mass Air Flow (MAF) Sensor.

STEP 2

• Loosen the two 10mm mounting bolts that

secure the factory intake system to the vehicle.

Also remove the clip on the passenger side of

the stock intake system using pliers.

• Remove the two vent hoses going into the

factory intake system.

The clip needs to be pushed back then rotated down

while pulling on the hose to release it from the fitting.

Summary of content (4 pages)

PAGE 1
2010-2013 Ford F-150 Raptor SVT 6.2L V8 Cold Air Induction Kit Part # 1831 Special Tools Required: • T-20 Torx Install Time: Approximately 1 Hour Difficulty: 2 out of 5 Follow these instructions carefully to ensure correct fitment and operation. STEP 1 • STEP 3 Disconnect the Mass Air Flow (MAF) Sensor. STEP 2 The clip needs to be pushed back then rotated down while pulling on the hose to release it from the fitting.
PAGE 2
010-2013 Ford F-150 Raptor SVT 6.2L V8 Cold Air Induction Kit Part # 1831 STEP 4 STEP 5 • Remove the MAF Sensor from the stock intake system using a T-20 Torx and install it into the BBK Cold Air Tube using the supplied hardware. NOTE!!! The Air Flow of the sensor needs to be going towards the throttle body, the sensor should only fit one way because of the stagger in the hole pattern. STEP 6 • Unclip the three clips at the air box and remove the entire system out of the vehicle.
PAGE 3
2010-2013 Ford F-150 Raptor SVT 6.2L V8 Cold Air Induction Kit Part # 1831 STEP 7 STEP 9 • • Install the sponge trimming onto the BBK Cold Air Intake shield and install the supplied plug into the BBK Air Filter. STEP 8 • Place the cold air shield into the vehicle on the bottom half of the factory air box and use the three original clamps to secure the shield. Install the blue BBK Coupler and BBK Intake Tube to the throttle body.
PAGE 4
2010-2013 Ford F-150 Raptor SVT 6.2L V8 Cold Air Induction Kit Part # 1831 STEP 11 STEP 12 • • Start the vehicle and let idle for a few minutes to ensure that there are no leaks and that the check engine light doesn’t come on. Install the supplied Air Filter, plug in the MAF Sensor and be sure all the clamps are tight.