Installation Manual

ManualsBrandsBBK Performance ManualsCar1765

Part # 1765- 2005-10 Ford Mustang V6

Part # 1758- 2004-06 Ford F-150 4.6L

Power Plus Series

Throttle Body

INS-110

Installation of this throttle body requires a digital voltmeter to check and set the TPS sensor

voltage of the stock throttle body to the BBK Throttle Body.

Follow these instructions carefully to ensure correct fitment and operation.

Special Tools

Required:

•

Digital Voltmeter

Install Time:

Approximately

45 Mins

Difficulty:

2 out of 5

STEP 3

• With a digital voltmeter set on DC volts, turn the

ignition to the ON position, but don’t start the

engine.

STEP 2

• MUSTANG: Probe the top wire of the TPS

Sensor.

• F150: Probe the closest wire to you on the TPS.

• Record the voltage reading. You will be

between 1.19 and 1.33V. Turn the key to the

OFF position.

• Disconnect the negative battery terminal.

STEP 1

Summary of content (4 pages)

PAGE 1
Part # 1765- 2005-10 Ford Mustang V6 Part # 1758- 2004-06 Ford F-150 4.6L Power Plus Series Throttle Body Special Tools Required: • Digital Voltmeter Install Time: Approximately 45 Mins Difficulty: 2 out of 5 Installation of this throttle body requires a digital voltmeter to check and set the TPS sensor voltage of the stock throttle body to the BBK Throttle Body. Follow these instructions carefully to ensure correct fitment and operation.
PAGE 2
Part # 1765- 2005-10 Ford Mustang V6 Part # 1758- 2004-06 Ford F-150 4.6L Power Plus Series Throttle Body STEP 4 STEP 7 • • Disconnect the breather tube from the air intake tube. Loosen the clamps at the throttle body and at the air box then remove the air intake tube. STEP 5 • Unplug the TPS sensor and throttle body motor control wires. Unbolt the throttle body from the intake manifold and place on a workbench. Remove the five Torq Head Screws and remove the motor cover and internal spring.
PAGE 3
Part # 1765- 2005-10 Ford Mustang V6 Part # 1758- 2004-06 Ford F-150 4.6L Power Plus Series Throttle Body STEP 9 • Pop off the round plastic cover on the motor cover. Install the cover on the throttle body. Using a small screwdriver, push the white spring retainer down while rotating it 160 degrees counter clockwise until the large and small tabs align with their slots. Release and allow the tabs to seat. STEP 11 • • With a 2.5mm allen wrench, loosen the set screw for the brass adjuster stud.
PAGE 4
Part # 1765- 2005-10 Ford Mustang V6 Part # 1758- 2004-06 Ford F-150 4.6L Power Plus Series Throttle Body STEP 15 • With your digital volt meter, recheck the voltage on the top wire. If the voltage is not the same as your first reading, then turn the brass adjuster stud to adjust the voltage reading until it is. Turn the ignition key to the OFF position. Disconnect the negative battery terminal. • Re-install the air intake tube and connect the breather tube. Reconnect the negative battery terminal.