Owners manual

ManualsBrandsBBK Performance ManualsAutomotive1607 Direct Fit High-Volume Electric Fuel Pump Kit Fits Mustang

1986-97 Ford Mustang GT/Cobra

Hi-Volume Fuel Pump Kits

Part # 1526,1527,1606,1607,1622

INS-012

Part# Application

Follow these instructions carefully to ensure correct fitment and operation.

Wiring connectors and other installation parts are not needed or supplied with all fuel pump

kits. For ease of installation the fuel tank should be as empty as possible.

Special Tools

Required:

•

No special tools

required

Install Time:

Approximately

1 Hour 30 Mins

Difficulty:

3 out of 5

STEP 5

• Place the rear of the vehicle on jack stands to

obtain adequate clearance.

STEP 2

• Start by removing the bolt on the filler neck

brace.

• Remove the tank completely from the vehicle

and using a spanner wrench or small chisel and

hammer, remove the lock ring for the fuel pump

assembly.

STEP 3

STEP 4

• Place a floor jack with a block of wood on it

under the tank to lower it.

• Unplug the wire harness at the rear, top of the

gas tank. Remove both bolts from the mounting

straps and slowly lower the tank. When the tank

is low enough to reach them, disconnect the fuel

lines and the vacuum line from the top of the

tank. As you remove the tank, slide the fill tube

out. NOTE!!! Be sure to check the condition

of the fill tube rubber seal at the fuel tank.

Replacements can be purchased at your

local Ford Dealer.

1526

1527

1606

1607

1622

110 lph, 1986-97 Mustang GT

155 lph, 1986-97 Mustang GT

190 lph, 1986-97 Mustang GT

255 lph,1986-97 Mustang GT

255 lph, 1996-97 Mustang Cobra

STEP 1

Summary of content (2 pages)

PAGE 1
986-97 Ford Mustang GT/Cobra Hi-Volume Fuel Pump Kits Part # 1526,1527,1606,1607,1622 Special Tools Required: • No special tools required Install Time: Approximately 1 Hour 30 Mins Difficulty: 3 out of 5 Part# 1526 1527 1606 1607 1622 Application 110 lph, 1986-97 Mustang GT 155 lph, 1986-97 Mustang GT 190 lph, 1986-97 Mustang GT 255 lph,1986-97 Mustang GT 255 lph, 1996-97 Mustang Cobra Follow these instructions carefully to ensure correct fitment and operation.
PAGE 2
1986-97 Ford Mustang GT/Cobra Hi-Volume Fuel Pump Kits Part # 1526,1527,1606,1607,1622 STEP 6 STEP 8 • • Remove the factory fuel pump from the tank by rotating and lifting the fuel pump/bracket assembly. Take care and keep maneuvering the pump assembly to remove. Reverse the disassembly steps to re-install. STEP 7 • Install the new pump and filter onto the factory bracket and re-install. Part #’s 1606, 1607, and 1622 you will be using supplied hardware with the fuel pump kit.