Owners manual

2015-2016 Ford Mustang 3.7L V6

H-Pipe

#1465/14650

INS-227

Follow these instructions carefully to ensure correct fitment and operation

Special Tools

Required:



No special tools

required

Install Time:

Approximately

30 mins

Difficulty:

2 out of 5

STEP 4

 Disconnect the negative battery terminal. Lift the

vehicle as high as possible utilizing approved

jack and jack stands.

STEP 2

 With the BBK Full Length Headers installed,

remove the (2) rear oxygen sensors from the

stock exhaust and transfer them over to the

BBK H-PIPE.

 Connect the (2) oxygen sensor extensions to

the wiring Harness’s on both sides of the

transmission. NOTE: Route the oxygen

sensor wiring over the transmission cross

member.

 Lift the stock exhaust into place and line it up

with the BBK H-Pipe, slide the barrel clamps

forward enough to connect the stock exhaust to

the BBK H-Pipe. NOTE: You will need to push

the complete exhaust towards the front of

the vehicle as far as possible to ensure that

the barrel clamps have enough grip length to

properly secure the exhaust pipes.

STEP 3

 Lift the BBK H-PIPE up to the collector flanges

on the headers, Connect the headers and H-

Pipe utilizing the hardware supplied in the

header kit. NOTE: just snug the bolts enough

to hold the BBK H-Pipe into place.

STEP 1

PAGE 1
2015-2016 Ford Mustang 3.7L V6 H-Pipe Special Tools Required:  No special tools required #1465/14650 Install Time: Approximately 30 mins Difficulty: 2 out of 5 Follow these instructions carefully to ensure correct fitment and operation STEP 1  STEP 3 Disconnect the negative battery terminal. Lift the vehicle as high as possible utilizing approved jack and jack stands.
PAGE 2
015-2016 Ford Mustang 3.7L V6 H-Pipe #1465/14650 STEP 5    With everything in place level out the exhaust and start tightening down all the hardware and clamps starting at the collectors and working your way towards the rear of the vehicle. Connect the oxygen sensor wires to the wire extensions. Reconnect the battery and start the engine to check for exhaust leaks. NOTE: Be sure to check and re-torque the exhaust clamps and hardware after 500 miles of driving.