Service manual

– 14 –
KDF-E42/50A11E
RM-ED002
32
GB
Option Description Programme Presets programme channels manually.
1 Press M/m to select “Programme”, then press OK. 2 Press M/m to select the programme number you want
to manually tune (if tuning a VCR, select channel 0), then press <.
3 Press M/m to select “System”, then press OK.
Note
Depending on the country/region selected for “Country” (page 26), this option may not be available.
4 Press M/m to select one of the following TV broadcast
systems, then press <.
B/G: for western European countries/regions D/K: for eastern European countries/regions I: for the United Kingdom L: for France
5 Press M/m to select “Channel”, then press OK. 6 Press M/m to select “S” (for cable channels) or “C” (for
terrestrial channels), then press ,.
7 Tune the channels as follows:
If you do not know the channel number (frequency)
Press M/m to search for the next available channel. When a channel has been found, the search will stop. To continue searching, press M/m. If you know the channel number (frequency) Press the number buttons to enter the channel number of the broadcast you want or your VCR channel number.
8 Press OK. 9 Press OK to select “Confirm”, then press OK. Repeat the procedure above to preset other channels manually.
System Channel Label Assigns a name of your choice, up to five letters or numbers, to the
selected channel. This name will be displayed briefly on the screen when the channel is selected.
1 Follow steps 3 to 5 of “Programme Labels” (page 31). 2 Press OK to select “Confirm”, then press OK.
AFT Fine-tunes the selected programme number manually if you feel
that a slight tuning adjustment will improve the picture quality. (Normally, fine tuning is performed automatically.)
1 Press M/m to adjust the fine tuning over a range of -15
to +15, then press OK.
2 Press OK twice.
To restore automatic fine tuning, select “On” in step 1.
33
GB
Using the Menu
Audio Filter Improves the sound for individual channels in the case of distortion
in mono broadcasts. Sometimes a non-standard broadcast signal can cause sound distortion or intermittent sound muting when watching mono programmes.
1 Press M/m to select “Low” or “High”, then press OK.
If you do not experience any sound distortion, we recommend that you leave this option set to the factory setting “Off”.
2 Press OK to select “Confirm”, then press OK. Note You cannot receive stereo or dual sound when “Low” or “High” is selected.
Skip Skips unused analogue channels when you press PROG +/- to
select channels. (You can still select a skipped channel using the number buttons.)
1 Press M/m to select “Yes”, then press OK. 2 Press OK to select “Confirm”, then press OK. To restore a skipped channel, select “No” in step 1.
Decoder Records the scrambled channel selected when using a decoder
connected to the scart connector / 2 either directly or via a VCR. Note
Depending on the country/region selected for “Country” (page 29), this option may not be available. 1 Press M/m to select “On”, then press OK. 2 Press OK to select “Confirm”, then press OK. To cancel this function afterwards, select “Off” in step 1.
ATT Attenuates the RF signal. In case of a strong RF signal, some video
interference may be displayed.
1 Press m/M to select “On”, then press OK. 2 Press OK to select “Confirm”, then press OK. Tip This option cannot be used if “AV2 Output” is set to “D-TV” (page 26)
Option Description
Continued