Installation Guide
Installation Instructions
Place the Bazooka UTube on the ATV rack. If being mounted to a at surface use the mounting bases. Remove bases from strap if being
used on a bar rack or if you do not want to mount strap bases. Wrap strap around the UTube then adjust strap to correct length. Fasten
the buckles as Illustrated. The strap should loop through the buckle and be tightened securely by holding the strap in place with one hand and
pulling the loose end away from the buckle, but against the cabinet. Then secure the hook & loop ends to the strap. Repeat with the 3
remaining straps.
UT6200 / UT6200RL
UT8200 / UT8200RL
Strap Placement
Strap Placement
Path of strap
With mounting base
Remove fuse from 6 ft power cable. Attach the red wire to the positive battery terminal. Attach the black wire to the
negative battery terminal. Run power cable to the location of the UTube. making sure power wire does not hinder
the safe operation of the vehicle. Plug the red power cable end into the UTube’s red input power plug. The black 12vdc
accesory plug can be used to power any 12vdc accessory up to 15 amps. Use the black accessory pigtail to wire your
accesories.




