If you have any questions contact the SAS Technical Support Department at: Phone - (504) 272 7135 Fax - (504) 272-9844 Email - tech@sasbazooka.com Website - www.sasbazooka.com In Canada: (604) 988 2966 15049 Florida Blvd., Baton Rouge, LA.
CONGRATULATIONS Dear Friend, Thank you for selecting Bazooka® subwoofer speaker systems for your car stereo system. The Bazooka Reference series represents SAS‘s continued commitment to efficiency and design. An innovative manufacturing process developed by SAS for the Bazooka provides consumers with state-of-the-art speaker system design.
PHASE ALERT CONT. Am I In Phase? If your inputs are out of phase and you turn the balance control of your radio all the way to one side, right or left, the bass output from the Bazooka will increase. When you bring the balance control back to the center position the bass level will drop. This confirms that one of your input channels is wired out of phase with the other. To correct this situation, simply reverse the connections on one of the two input channels.
TURN ON OPTIONS CONT. SYSTEM FEATURES pins and reinserted across the left hand and middle pins to enable the Auto Turn-On feature. This can be done easily with a pair of needle nose pliers. With the jumper in the On position, the Amplified Bazooka will turn on automatically when it senses any music. The ORANGE wire should not be connected to anything if this feature is being used. Be sure to insulate the end of the ORANGE wire so that it will not short to ground, as this may damage the Amplified Bazooka.
GROUND WIRE CONT. INSTALLATION The ground point in the car should be a piece of chassis metal that is part of or welded to the main body of the vehicle. Painted surfaces should be scraped or sanded clean to expose the bare metal before the ground lug is bolted down. (Cover the bare metal area with paint or grease after you finish mounting the ground wire to prevent rust.) REMOTE TURN ON OPTIONS TRUCK INSTALLATION Figure 1 The ORANGE wire on the Amplified Bazookas' 14-pin Molex Mini-fit Jr.
INSTALLATION Please take time to read through this manual and plan out your installation before you begin! Locate an area in the rear of the vehicle where you would like to place the Bazooka speaker systems. The location you have selected must meet the following requirements in order for the Bazooka to be properly installed in the vehicle: 1) The woofer (grill end) should be facing into a corner.
WIRING DIAGRAM MOUNTING THE BAZOOKA When using high level inputs, take the time after you make all wiring connections to run through the AM I IN PHASE? procedure of this manual to confirm that your inputs are in correct electrical phase and the proper bass response is being produced. 1. With the top side of the buckle facing up (see figure 4), lace the strap through the mounting base as illustrated in figure 5.
MOUNTING THE BAZOOKA MOUNTING THE BAZOOKA 3. Place each mounting base under the Bazooka so that the apex at the bottom of the tube sits inside the mounting base as in figure 7. See Model Size For Length Figure 9 4. Move the bases so that they are spaced approximately 3” from each end of the enclosure as illustrated in figure 8. Figure 7 Model Length RS6A RS8A RS10A 17” 22” 27” 8. Remove any slack in the strap by feeding it out of the mounting base on the loose end of the strap opposite the buckle.
MOUNTING THE BAZOOKA MOUNTING THE BAZOOKA 3. Place each mounting base under the Bazooka so that the apex at the bottom of the tube sits inside the mounting base as in figure 7. See Model Size For Length Figure 9 4. Move the bases so that they are spaced approximately 3” from each end of the enclosure as illustrated in figure 8. Figure 7 Model Length RS6A RS8A RS10A 17” 22” 27” 8. Remove any slack in the strap by feeding it out of the mounting base on the loose end of the strap opposite the buckle.
WIRING DIAGRAM MOUNTING THE BAZOOKA When using high level inputs, take the time after you make all wiring connections to run through the AM I IN PHASE? procedure of this manual to confirm that your inputs are in correct electrical phase and the proper bass response is being produced. 1. With the top side of the buckle facing up (see figure 4), lace the strap through the mounting base as illustrated in figure 5.
INSTALLATION Please take time to read through this manual and plan out your installation before you begin! Locate an area in the rear of the vehicle where you would like to place the Bazooka speaker systems. The location you have selected must meet the following requirements in order for the Bazooka to be properly installed in the vehicle: 1) The woofer (grill end) should be facing into a corner.
GROUND WIRE CONT. INSTALLATION The ground point in the car should be a piece of chassis metal that is part of or welded to the main body of the vehicle. Painted surfaces should be scraped or sanded clean to expose the bare metal before the ground lug is bolted down. (Cover the bare metal area with paint or grease after you finish mounting the ground wire to prevent rust.) REMOTE TURN ON OPTIONS TRUCK INSTALLATION Figure 1 The ORANGE wire on the Amplified Bazookas' 14-pin Molex Mini-fit Jr.
TURN ON OPTIONS CONT. SYSTEM FEATURES pins and reinserted across the left hand and middle pins to enable the Auto Turn-On feature. This can be done easily with a pair of needle nose pliers. With the jumper in the On position, the Amplified Bazooka will turn on automatically when it senses any music. The ORANGE wire should not be connected to anything if this feature is being used. Be sure to insulate the end of the ORANGE wire so that it will not short to ground, as this may damage the Amplified Bazooka.
PHASE ALERT CONT. Am I In Phase? If your inputs are out of phase and you turn the balance control of your radio all the way to one side, right or left, the bass output from the Bazooka will increase. When you bring the balance control back to the center position the bass level will drop. This confirms that one of your input channels is wired out of phase with the other. To correct this situation, simply reverse the connections on one of the two input channels.
CONGRATULATIONS Dear Friend, Thank you for selecting Bazooka® subwoofer speaker systems for your car stereo system. The Bazooka Reference series represents SAS‘s continued commitment to efficiency and design. An innovative manufacturing process developed by SAS for the Bazooka provides consumers with state-of-the-art speaker system design.
If you have any questions contact the SAS Technical Support Department at: Phone - (504) 272 7135 Fax - (504) 272-9844 Email - tech@sasbazooka.com Website - www.sasbazooka.com In Canada: (604) 988 2966 15049 Florida Blvd., Baton Rouge, LA.
