Specifications

TOYOTA TUNDRA D-CAB 2004 - VSE SUBWOOFER (JBL)
Procedure
(g) Route wire harness along the factory harness
and wire tie as shown. (Fig. 8f & 8g)
Fig. 8g
Harness
clip
Fig. 8f
(1) Start the wire tie outside the pillar cover
and slide up the harness, tighten to the
existing harness clip and cut off excess.
(h) Continue to route the wire harness along the
factory harness and connect to the amplifier
as shown. (Fig. 8h)
Fig. 8h Fig. 8i
(i) Using the supplied 10mm bolt, install the
ground ring onto the vehicle accommodated
weld nut. (Fig. 8i)
Fig. 8j
Wire t
to clip
ie
Foam tape
on back of
connectors
Wire tie
to bracket
Keep clear for
panel clip
(1) Torque bolt to 10 lbf·ft
(j) Connect wire harness to the vehicle wire
harness and route as shown.
(1) The wire harness must be routed so as not
to interfere with the panel clip. (Fig. 8j)
(2) Foam tape wrap the back of connectors to
prevent rattles. (Fig. 8j)
(3) Wire tie to the metal bracket and to the
existing wire harness clip as shown.
(Fig. 8j)
6. In Process Functional Test.
(a) Reconnect the harness to the radio.
(1) Reconnect the Satellite radio harness if so
equipped
(2) Reconnect antennae cable.
(b) Reinstall radio.
(1) Be sure the wire harness is not pinched.
(c) Securely fasten (hand tighten) the four (4)
mounting fasteners using the 10mm socket.
DO NOT OVER TIGHTEN
Issue: A 12/22/04
Page 4 of 11 pages