Dear Friend, At SAS, we take pride in manufacturing the most revolutionary bass speaker systems ever created, featuring our patented Bass Tubes® enclosure design, and we hope you will take pride in owning them. Several years ago, we realized that efficiency was the wave of the future in Autosound, so we made a commitment to design, manufacture, and deliver the most efficient speaker systems possible.
ENGLISH CONTENTS HELPFUL HINTS BEFORE YOU BEGIN PG 4 VEHICLE PLACEMENT RECOMMENDATIONS PG 5-6 MOUNTING THE BAZOOKA PG 7-9 WIRING DIAGRAMS PG 10-11 SPECIFICATIONS PG 12&15 FEATURES PG 13-14 WIRING PG 16-20 TROUBLESHOOTING PG 21-22 WARRANTY PG 24-25 3
HELPFUL HINTSBEFORE YOU BEGIN Please take time to read through this manual and plan out your installation before you begin! 1) The woofer (grill end) should be facing into a corner. (See vehicle placement recommendations on pg. 5-6) 2) Ideally, there should be 2 to 4 inches between the woofer and the corner it is pointing into.
VEHICLE PLACEMENT RECOMMENDATIONS ENGLISH TRUCK INSTALLATION tube size is exaggerated for emphasis HATCHBACK INSTALLATION tube size is exaggerated for emphasis SEDAN INSTALLATION tube size is exaggerated for emphasis 5
BOAT PLACEMENT RECOMMENDATIONS ENGLISH BOW RIDER/SKI BOAT tube size is exaggerated for emphasis Under passenger console Under seat storage compartment SPORT YACHT tube size is exaggerated for emphasis Under bed storage compartment Under seat storage compartment 6
ENGLISH MOUNTING THE BAZOOKA Figure 1 Top Logo should face up 1. With the topside of the buckle facing up (see figure 1), lace the strap through the mounting base as illustrated in figure 2 Figure 2 Figure 3 2. After the strap is completely laced through the mounting base, make a loop with the strap, where it runs across the middle of the base as illustrated in figure 3. This loop is necessary to access the two mounting holes in the base.
ENGLISH Figure 4 3. Place each mounting base under the Bass Tubes® enclosure so that the apex at the bottom of the tube sits inside the mounting base as in figure 4. ,, 3 Figure 5 3 ,, 4. Move the bases so that they are spaced approximately 3 from each end of the enclosure as illustrated in figure 5. 5. Remove the Bass Tubes® enclosure without moving the mounting bases and set it aside. 6. Screw each mounting base securely in place with screws provided as illustrated in figure 3.
28 oz. Magnet Size 4 ohms Impedance 4 ohms 23 lbs. 20.75 x 10.3 x 12.2 6-200 watts/channel 104 dB* 39-1000 hz. 28 oz. 1.5 high power. /high temp. 10 MBT1014 2 ohms DVC 14 lbs. 18.125x8.5x10 100 watts 105 dB* 39-85 hz. 15 oz. 1.5 high power/high temp 8 MBTA8100 2 ohms DVC 24 lbs. 20.875x10.3x12.2 100 watts 107 dB* 39-85 hz. 28 oz. 1.5 high power. /high temp. 10 MBTA10100 4 ohms 20 lbs. 18.325" x 8.5" x 10" 200 watts 102 dB* 39-250 hz. 28 oz. 1.
DO NOT substitute the fuse included with the Amplified Bazooka subwoofer with anything other than the SAME fast blow current rated fuse. Substitution or deletion will void the product's warranty and may cause damage to your car or the amplifier. SHOULD I USE HIGH OR LOW LEVEL INPUTS? If the source unit has only speaker outputs, use the high-level inputs of the Amplified Bazooka subwoofer.
ENGLISH procedure at the end of this manual to confirm that your inputs are in correct electrical phase and the proper bass response is being produced. Low-Level Inputs: If your source unit only has low-level RCA phono jack output, use only the low-level inputs of the Amplified Bazooka. Connect the low-level RCA phono jack inputs of the Amplified Bazooka subwoofer to the source with a shielded RCA patch cord.
or grease after you finish mounting the ground wire to prevent rust.) OPTION ONE: When you are using this option with all amplified Bass Tubes® models: For the most versatility the Orange Remote Turn On Wire should be connected to the source unit's "Accessory", "Auto-Antenna" or "Remote" lead -- any of which will supply 12 Volts positive when the source is turned on.
ENGLISH ADJUSTING THE CROSSOVER A200 ONLY The built-in crossover on the Amplified Bazooka subwoofer is an 18 dB per octave electronic low pass filter, it has a 60 Hz to 250 Hz variable crossover point. Select the crossover point that you feel best fits your system design. Set the potentiometer labeled XOVER to the point you selected, 60 Hz being all the way to the left (counterclockwise) and 250 Hz being all the way to the right (clockwise). When you have set the crossover, proceed to the next step.
All A200 MODELS These Remote Controls are accessories that are available from your Bazooka dealer or directly from Bazooka. Be sure to check out other optional accessories for your Bazooka at PASSIVE MODELS (BT6014/6018, BT8014/8018, BT1014/1018, MBT8014, MBT1014 ONLY) On the back of all Bazooka passive single voice coil models you will find a terminal cup with two 5-way platinum colored binding posts, red being positive and black being negative.
ENGLISH TROUBLESHOOTING Am I In Phase? If your inputs are out of phase and you turn the balance control of your radio all the way to one side, right or left, the bass output from the Bazooka® will increase. When you bring the balance control back to the center position the bass level will drop. This confirms that one of your input channels is wired out of phase with the other.
PHASE CORRECTING PROCEDURE Disconnect all but one Bazooka® from your system. Be sure that any loose wire connections are insulated to avoid the chance of short-circuiting any of the electronic equipment. Listen to the system and take note of the level of the Bass Response. Connect the next Bazooka® and compare the level of the combined output to that of the single unit. If the Bass Response increases, the Phasing is correct and you can repeat this process on the next Bazooka.
ENGLISH LIMITED WARRANTY (UNITED STATES) Southern Audio Services, Inc., warrants all products to be free from defects in material and workmanship for a period of one (1) year from the date of purchase. In the event the product is not as warranted, SAS sole obligation shall be to repair or replace the defective product at SAS option: SAS limits its obligation under any implied warranties under state laws to a period not to exceed the limited warranty period.
PLEASE RETURN THIS PORTION IMMEDIATELY ____________________________________________ SERIAL# ____________________________________________ PURCHASE DATE ____________________________________________ DEALER PURCHASED FROM ____________________________________________ DEALER ADDRESS ____________________________________________ TELEPHONE ____________________________________________ PURCHASERS NAME ____________________________________________ STREET ADDRESS ____________________________________________ CITY _______
