Owner`s manual
61
IMPORTANT: When using Direct Line Type and you change the
baud rate of the local unit's composite port, the remote unit's
composite port baud rate must then be changed in order to re-
establish MUX mode with the local unit.
The Telplex will now return to the main configuration menu (see
Section 5.1
).
)
By responding to the
Enter Request:
message at the end of the main
configuration menu with "X" (Exit), the Telplex will return to System
mode.
NOTE: This section does not apply to standard units.
This section is intended to provide the necessary configuration
requirements for various multi-drop applications. We will give specific
instructions on how to configure each unit. We assume that all
terminal devices and modems communicate at the factory default
serial parameters. The configuration parameters we will consider in
this section are the Serial Port Destination and Unit Number.
*!!*
The first example application we will consider is a "point-to-point"
application.
Figure 9
below shows two TX104s. This application links
mainframe ports at one site to terminals at another site. The TX104
with the main frame ports connected to it will be Unit 1 and the TX104
with the terminals connected to it will be Unit 2.
Figure 9