Owner`s manual

56
Following our example, type "3" (For Power/DCD) to send String 1 out
upon power-up or loss of DCD.
NOTE: If you select "4" (For Manual), the programmable string will
only be sent manually by typing Control-U for String 1 or by typing
Control-V for String 2 when the Telplex is in Access Local Modem
mode (multi-drop units) or Local mode (standard units). Regardless
of the selection, String 1 will always be sent when the active terminal
sends Control-U and String 2 will always be sent when this device
sends Control-V from either mode.
The Telplex will respond with:
+--------+------------------------------------------+----------+
| String | Programmable String | Send On: |
+--------+------------------------------------------+----------+
| 1 | ATDT15551234567^M | Power/DCD|
+--------+------------------------------------------+----------+
| 2 | | Manual |
+--------+------------------------------------------+----------+
String 1.......................1 String 1 Send On........3
String 2.......................2 String 2 Sent On........4
Enter Number 1-4 to Change or X to Exit:
NOTE: String 1 will be sent out of the composite port whenever the
SELECT switch is pressed for more than three seconds while the
Telplex is in System/Local mode or in an idle state regardless of the
condition selected above.
You may now enter another request or "X" to return to the main
configuration menu (see Section 5.1 ).