Owner`s manual

55
Enter the desired string (up to 42 characters). If String 1 must include
control characters, use the prefix ^ (5E hex or ASCII 94) to represent
the Control key. For example, if you want the string to include
Control-T , you would enter ^T in response to the prompt along with
the rest of the desired string. The entry must be followed by the
<ENTER> key.
NOTE: All AT commands require a Carriage Return at the end of the
command(s) before the modem will execute the command(s).
Therefore, ^M ( Control-M or Carriage Return ) should be the last
character entered in either programmable string.
For example, if you want the local unit to send String 1 to instruct the
external modem to tone dial the remote unit's external modem at
number 1-555-123-4567 upon power-up or loss of DCD, you would
first enter the following string:
Enter Up to 42 Characters to be Sent for String:
ATDT15551234567^M
The Telplex will respond with:
+--------+------------------------------------------+----------+
| String | Programmable String | Send On: |
+--------+------------------------------------------+----------+
| 1 | ATDT15551234567^M | Manual |
+--------+------------------------------------------+----------+
| 2 | | Manual |
+--------+------------------------------------------+----------+
String 1.......................1 String 1 Send On........3
String 2.......................2 String 2 Sent On........4
Enter request or X to Exit:
If you wish to change the condition on which String 1 will be sent out
the composite port, type "3" (String 1 Send On) in response to the
prompt at the end of the Programmable String submenu. The Telplex
will respond with:
1 For Power Up
2 For DCD Off
3 For Power/DCD
4 For Manual
Enter Request: