Owner`s manual

54
If the current values for Block Size, Local Access, and Status
Messages are satisfactory, type "X" in response to the prompt. The
Telplex will respond with an updated status menu for all terminal ports
and a prompt to enter another port number. You can now enter
another terminal port number to change or "X" to exit back to the main
configuration menu (see Section 5.1 ).
 
By responding to the Enter Request: message at the end of the main
configuration menu (see Section 5.1.1 ) with "4" for a multi-drop unit or
"5" for a standard unit (Programmable Strings), you may review the
current status of the Programmable Strings and make any necessary
changes. There are two programmable strings which are sent out of
the composite port to the external modem under various conditions.
Either string may be sent on power-up, loss of DCD, power-up and
loss of DCD, or manually via control characters.
NOTE: The programmable strings will be sent only if you have the
Telplex programmed to have Modem Line Type.
The Telplex will respond with:
+--------+------------------------------------------+----------+
| String | Programmable String | Send On: |
+--------+------------------------------------------+----------+
| 1 | | Manual |
+--------+------------------------------------------+----------+
| 2 | | Manual |
+--------+------------------------------------------+----------+
String 1.......................1 String 1 Send On........3
String 2.......................2 String 2 Send On........4
Enter request or X to Exit:
Enter the number corresponding your desired choice. For example, if
you enter "1" (String 1), the Telplex will respond with:
Enter ASCII string 42 characters max.
Use Prefix ^ for Ctrl-Characters