Owner`s manual

51
 "'

By responding to the Enter Request: message at the end of the main
configuration menu (see Section 5.1.1 ) for either type of unit with "3"
(Block Size, Port Local Access, and Status Messages), you may
review the current status of the Block Size, Local Access, and Status
Messages and make any necessary changes. The Telplex will
respond with:
+------+------+------+------------+
| Port | Block|Local | Status |
| | Size |Access| Messages |
+------+------+------+------------+
| 1 | 032 | YES | ON |
| 2 | 032 | NO | OFF |
| 3 | 032 | NO | OFF |
| 4 | 032 | NO | OFF |
+------+------+------+------------+
Enter Port Number 1-4 or X to Exit:
Type the port number that you wish to configure followed by
<ENTER>. The Telplex will then proceed to a status menu for the
port you enter and a list of options to change. For example, if you
enter " 2 " followed by <ENTER> for Port 2 in response to the prompt,
the Telplex will respond with:
+------+------+------+------------+
| Port | Block|Local | Status |
| | Size |Access| Messages |
+------+------+------+------------+
| 2 | 032 | NO | OFF |
+------+------+------+------------+
Set Block Size.......1
Set Local Access.....2
Set Status Messages..3
Enter Request or X to Exit:
You may now change the current Block Size, Local Access, or Status
Messages for Port 2. For example, if you want to change the current
Block Size for Port 2, type "1" in response to the prompt. The Telplex
will respond with:
Enter Transmit Block Size (1 to 255) :