Owner`s manual

50
CAUTION: If the configuration of the device you are configuring from
is not changed to match the new configuration of the port, you will be
locked out of the Telplex and unable to access its functions. If this
happens, cycle power on the unit and re-enter Local Unit
Configuration mode.
If you enter "Y", the new configuration for that port will be stored
permanently in non-volatile memory and the Telplex will subsequently
power-up at that configuration. If you enter "N", the new configuration
will be stored in RAM and on the next power-up, the Telplex will revert
to the previous configuration.
The Telplex will respond with:
+------+------+------+------+------+------+------+-------+
| Port | Baud | Word | Stop |Parity| Xon / Xoff | PASS |
| | Rate | Size | Bits | | Xmit | Recv |RTS-DSR|
+------+------+------+------+------+------+------+-------+
| 1 | 9600| 8 | 1 | NONE | OFF | OFF | NO |
| 2 | 9600| 8 | 1 | NONE | OFF | OFF | NO |
| 3 | 2400| 8 | 1 | NONE | ON | OFF | NO |
| 4 | 9600| 8 | 1 | NONE | OFF | OFF | NO |
+------+------+------+------+------+------+------+-------+
Enter Port Number 1-4 or X to Exit :
You may now reconfigure another port or type "X" to exit back to the
main configuration menu (see Section 5.1 ).