Owner`s manual

You may now select other options from the menu to reconfigure Port

3. For example, to set XON/XOFF handshaking in the transmit data

direction, send "6" (Set Xon/Xoff Xmit) in response to the prompt.

The Telplex will respond with:

Output Flow Control (Xmit) - Xon/Xoff is ( OFF )

Stop/Restart Output Upon Receiving of Xoff/Xon ? (Y/N) :

You should then type "Y" to enable Xon/Xoff on transmit or "N" to

disable XON/XOFF on transmit. For example, if you entered "Y", the

Telplex will respond with:

Input Flow Control (Recv) - Xon/Xoff is ( OFF )

Xoff/Xon sent base on Buffer - Full/Empty condition ? (Y/N) :

You should then type "Y" to enable XON/XOFF on receive or "N" to

disable XON/XOFF on receive. For example, if you enter "N", the

Telplex will respond with the reconfigured status of the port and

options menu as follows:

+------+------+------+------+------+------+------+-------+

+------+------+------+------+------+------+------+-------+

| 3 | 2400 | 8 | 1 | None | ON | OFF | NO |

+------+------+------+------+------+------+------+-------+

Exit/Save......1 Set Parity................5

Set Baud Rate..2 Set XON/XOFF Xmit.........6

Set Word Size..3 Set XON/XOFF Recv.........7

Set Stop Bits..4 Set RTS/DSR Pass Through..8

Enter Request:

If there are no other changes for this port, send "1" (Exit/Save) and

the Telplex will respond with:

Save Changes Permanently ? (Y/N) :

NOTE: If you happen to be changing the configuration for the port

you are physically connected to, the Telplex will respond with:

Change This Device to NEW Configuration

Before Answering This Request.

Save Changes Permanently? (Y/N) :

This reminds you to change the configuration of the device you are

configuring from to match the new configuration of the port before

answering the save changes prompt.