Owner`s manual
47
Current Unit Number is: 1
+-------+------------------------------------------+----------+
| String| Programmable String | Send On |
+-------+------------------------------------------+----------+
| 1 | | Manual |
+-------+------------------------------------------+----------+
| 2 | | Manual |
+-------+------------------------------------------+----------+
Press any Key to continue
NOTE: The "Remote Destination" and "Current Unit Number" menus
shown above and on the previous page will not appear for a standard
unit.
The Telplex will then return to the respective main configuration
menu. You may now make whatever changes are necessary. Typing
"X" will return you to the System menu or the Local Mode menu.
By responding to the
Enter Request:
message at the end of the main
configuration menu (see
Section 5.1.1
) for either type of unit with "2"
(Serial Port Configuration), you may review the current serial port
status of all terminal ports and make any necessary changes. Serial
port configuration for the composite port is described in
Section 5.8
.
Programmable serial parameters for the terminal ports include baud
rate, word size, stop bits, parity, XON/XOFF handshaking in the
transmit data (Xmit) and receive data (Recv) directions, and RTS/DSR
pass through. The Telplex will respond with:
+------+------+------+------+------+------+------+-------+
| Port | Baud | Word | Stop |Parity| Xon / Xoff | PASS |
| | Rate | Size | Bits | | Xmit | Recv |RTS-DSR|
+------+------+------+------+------+------+------+-------+
| 1 | 9600| 8 | 1 | NONE | OFF | OFF | NO |
| 2 | 9600| 8 | 1 | NONE | OFF | OFF | NO |
| 3 | 9600| 8 | 1 | NONE | OFF | OFF | NO |
| 4 | 9600| 8 | 1 | NONE | OFF | OFF | NO |
+------+------+------+------+------+------+------+-------+
Enter Port Number 1-4 or X to Exit :