Owner`s manual

44
NOTE: If you choose Remote Unit Configuration for a multi-
drop unit, the local Telplex will first prompt you to enter the
desired unit number and module number of the remote Telplex.
The module number will be "1" for a remote TX102, TX104,
TX108, or TX4. The module number will be 1 to 8 for a remote
TX28 or 1 to 16 for a remote TX60.
 
Section 5.1.1 shows the main configuration menu for multi-drop units.
Section 5.1.2 shows the main configuration menu for standard units.
 !

A multi-drop Telplex will respond to "1" (Local Unit Configuration) or
"2" (Remote Unit Configuration) while in System mode with a menu
similar to the following:
Bay Technical Associates
TELPLEX Model TX104 Statistical Multiplexer
Copyright 1990-1994
Revision 3.03
Unit 1, Module 1
Status........................................1
Serial Port Configuration.....................2
Block Size, Local Access & Status Messages....3
Programmable Strings..........................4
Set Serial Port Destination...................5
Set This Unit Number..........................6
Composite Port Configuration..................7
Exit to System Menu...........................X
Enter Request:
NOTE: If you select Remote Unit Configuration, item 7 (Composite
Port Configuration) will not be shown. This is because changing the
composite port for a remote Telplex while in Remote Unit
Configuration mode will disrupt the connection between the units.
NOTE: Menu selection is case sensitive. It is recommended that your
keyboard be in the CAPS LOCK position.