Owner`s manual

43
To access Local or Remote Unit Configuration mode for either type of
Telplex, use the following procedure:
1. Connect a dumb terminal or a computer emulating a dumb
terminal to the desired terminal port (factory default is Port 1).
Make sure your terminal device is configured to operate at the
same serial parameters as the terminal port on the Telplex.
Factory default is 9600 baud rate, 8 bit word size, 1 stop bit, no
parity, and XON/XOFF handshaking disabled.
2. Send the Escape Code Sequence (one second delay followed
by +++ and another one second delay). If you are
programming a multi-drop unit, you will receive the System
Menu similar to the following for the TX104:
TELPLEX TX104 SYSTEM MENU
Local Unit Configuration......1
Remote Unit Configuration.....2
Mux Mode......................3
Local Diagnostics.............4
Remote Diagnostics............5
Access Local Modem............6
Enter Request
:
If you are programming a standard unit, you will receive the
Local Mode menu similar to the following for the TX104:
3. If you are programming a multi-drop unit, Type "1" for Local
Unit Configuration or "2" for Remote Unit Configuration in
response to the prompt. If you are programming a standard
unit, type Control-T for Local Unit Configuration or Control-R for
Remote Unit Configuration. From this point on, configuration of
the Telplex is accomplished by following the menus that prompt
you.