Owner`s manual
35
NOTE: This section does not apply to standard units.
If you type "6" (Access Local Modem) from the Telplex System Menu
(see
Section 4.3.1
), the Telplex will respond with the following:
COMMUNICATING WITH MODEM
Type Ctrl U to Send String 1
Type Ctrl V to Send String 2
Type Ctrl X to exit to System Menu
Here, you will be communicating in full duplex with the composite port.
Anything you type on your keyboard will be sent to the modem and
anything received by the modem will appear on your terminal screen.
Type
Control-U
or
Control-V
to send Programmable String 1 or String
2 respectively as described in
Section 4.2.2.3
. If you type
Control-X
,
the Telplex will return to the System Menu.
!
If using Modem Line Type and the power switch is turned on, the
Telplex will go through the following sequence:
1) Perform a short self test.
2) Send the Programmable String(s) if programmed (see
Section 4.2.2.3
).
3) Go into an idle state and either wait for a terminal to
send the Escape Code Sequence (+++) and go into
System mode/Local mode or wait for the local modem to
send a
CONNECT
message or a low to high transition of
DCD and go into MUX mode.