Owner`s manual

34
If the remote unit fails its self-test, the local Telplex will display one of
the following messages:
Self-test Failed on Processor
Self-test Failed on Memory
Self-test Failed on Register
Self-test Failed on Port X
If you get one of these messages, call BayTech at 1-800-523-2702.
The local Telplex will return to the "Run Diagnostic" menu shown on
the previous page. If you type "2" from this menu (Full Duplex to a
select port), you may communicate with a selected port on the remote
unit with full duplex communication. The local Telplex will first prompt
you to type the desired remote unit port number (1 to 8). For example
if you type "4" for Port 4, the local Telplex will respond with:
Connected to port 4, enter ^C to quit
At this point, you are connected to Port 4 of the remote unit in full
duplex communication. Any data sent by the active terminal will be
sent to Port 4 of the remote unit and any data sent by Port 4 of the
remote unit will appear on your terminal screen. Either device may
terminate this diagnostic by typing Control-C . The local Telplex will
return to the "Run Diagnostic" menu shown on the previous page.
If you type "3" from the "Run Diagnostic menu (Loop Back
communication on a select port), you may perform loopback
communication with a selected terminal port on the remote unit. The
local Telplex will first prompt you to type the desired remote unit port
number (1 to 8). For example, if you type "4" for Port 4, the local
Telplex will respond with:
Loop Back on Port 4, enter ^C to quit
Any characters typed by the active terminal will be echoed back to the
terminal screen by Port 4 of the remote unit. Either device may
terminate this diagnostic by typing Control-C . The local Telplex will
return to the "Run Diagnostic" menu shown on the previous page. If
you type "X" from this menu, the local unit will return to the "Remote
Configuration Mode" menu shown on the previous page.