Owner`s manual

31
NOTE: The menu for Remote Diagnostics is identical to this menu
except the header will read "Remote Diagnostics Menu". When
performing remote unit diagnostics, the local Telplex will first prompt
you to enter the desired remote Telplex Unit Number followed by the
desired remote module number regardless of the diagnostic you
select. The remote module number will be "1" for a remote TX102,
TX104, TX108, or TX4. The remote module number will be 1 to 8 for
a TX28 and 1 to 16 for a TX60.
Enter the number corresponding to the desired diagnostic test. For
example, if you enter "1" (Full Duplex Communication With Selected
Port), the Telplex will respond with a prompt to enter the desired port
number. Enter the desired port number. For example, if you choose
Port 2, the Telplex will respond with:
Connected To Port 002, Type Ctrl X to exit to System Menu
NOTE: You cannot do full duplex diagnostics with a remote TX4,
TX28, or TX60 terminal port having a Serial Port Destination of Unit X,
Module 1, Port 1. If you are performing remote diagnostics on Unit X
(X = 1 to 32), Module Y (Y = 1 to 16), this menu will shown the
following:
Connected to Unit 00X, Module 00Y, Port 002
Type +++ to Return to System Menu
At this point you are in full duplex communication mode with Port 2.
Anything you type will be transmitted out Port 2 and anything received
by Port 2 will appear on your terminal screen. If performing local unit
diagnostics, type Control-X to terminate this diagnostic or +++ if
performing remote unit diagnostics. In either case, the Telplex will
return to System mode.