Owner`s manual

27
NOTE: Item "6" (Access Local Modem) will appear in the System
Menu only when using Modem Line Type. If using Modem Line Type
and the Telplex enters System mode, the unit will send +++ to the
external modem which will put the modem into command mode. The
Telplex will send ATO to the local modem when you type "3" (Mux
Mode) from the System Menu. This will instruct the local modem to
return to data mode.
Type "1" to enter Local Unit Configuration mode, "2" to enter Remote
Unit Configuration mode, "3" to enter MUX mode, "4" to enter Local
Diagnostics mode, "5" to enter Remote Diagnostics mode, or "6" to
enter Access Local Modem mode. The Telplex will return to System
mode when exiting Local/Remote Unit Configuration mode or
Diagnostics mode.
If System mode is currently accessed by another terminal port, the
Telplex will send the following message:
System Menu Currently Being Accessed by another Port
Standard Units: Local Mode
Once a terminal connected to a standard unit has accessed Local
mode, the Telplex will send back the Local Mode menu as follows:
LOCAL MODE
Type Ctrl C for Mux Mode
Type Ctrl T for Local Configuration
Type Ctrl R for Remote Configuration
Type Ctrl P or +++ for Modem Command
Type Ctrl U to Send String 1
Type Ctrl V to Send String 2
NOTE: The last three items of this menu will appear in the Local
Mode menu only when using Modem Line Type. Communication with
an external modem is done from this menu. If you wish to issue
commands to the local modem, you must first instruct the modem to
go into command mode by either typing Control-P or +++. If you wish
to return to MUX mode, first type Control-P followed by Control-C .
The Telplex receives Control-C , it will sent the ATO command to the
external modem to instruct the modem to return to data mode.