Owner`s manual

22
A standard unit will send a message similar to the following for a
TX104 when the Telplex is powered up and when MUX mode is
terminated (see Section 4.3.3 ):
TX104 in Local mode --- Type +++ to Access Local Mode
When a standard unit enters into MUX mode, the Telplex will send the
following message:
TX104 in MUX mode
A multi-drop unit will send the following message when the Telplex is
powered up and when returning to MUX mode from System mode
(see Section 4.3.1 ):
TELPLEX IN MUX MODE
Type +++ to Access System Menu
While a local terminal port on a multi-drop unit is waiting for a
connection to its designated remote terminal port, the following
message will be sent:
Waiting for Connection!
After a connection is made, the following message will be sent from a
multi-drop unit:
Connect To Unit X, Module Y, Port Z
where X is the designated unit number, Y is the designated module
number and Z is the designated port number (see Section 4.1.2.5 ).
If a multi-drop unit has a connection with its designated remote
Telplex and the connection is terminated, the Telplex will send the
following message:
Port Disconnected
Status messages will also be generated when a local terminal enters
into System/Local mode (see Section 4.3.1 ) or Diagnostics mode (see
Section 4.3.4 ).
The factory default has Status Messages enabled for Port 1 and
disabled for all other ports.