Owner`s manual

11
 
From the factory, the Telplex terminal ports come with the following
power-up default configuration:
Baud rate: 9600,
Word size: 8 bits,
Stop bits: 1 bit,
Parity: None,
XON/XOFF TX and RX: Disabled.
RTS/DSR pass through: Disabled.
Block Size: 32 characters.
Local Access: Enabled for Port 1 only.
Status Messages: Enabled for Port 1 only.
Serial Port Destination (multi-drop units only):
Port 1: Unit 1, Module 1, Port 1
Port 2: Unit 1, Module 1, Port 2
Port 3: Unit 1, Module 1, Port 3
Port 4: Unit 1, Module 1, Port 4
Port 5: Unit 1, Module 1, Port 5
Port 6: Unit 1, Module 1, Port 6
Port 7: Unit 1, Module 1, Port 7
Port 8: Unit 1, Module 1, Port 8
Unit Number (multi-drop units only): 1
From the factory, the Telplex composite port comes with the following
power-up configuration:
Baud rate: 9600.
Word size: 8 bits.
Stop bits: 1.
Line Type: Direct.
* String 1: Null; sent manually.
* String 2: Null; sent manually.
* - Applicable only if Line Type is Modem..
If your application does not match this factory setup, you must
reconfigure your Telplex as described in Section 5 .