Owner`s manual

8
USER-PROGRAMMABLE CONFIGURATIONS:
Programmed in Local or Remote Unit Configuration mode
(except the composite port). Changes are saved in non-volatile
memory to become the power-up default configuration.
Terminal Ports:
Baud rate: 50, 75, 110, 135, 150, 300, 600, 1200,
2400, 4800, 9600, or 19200.
Word size: 5, 6, 7 or 8 bits.
Stop bits: 1, 1 1/2, or 2.
Parity: Even, odd or none.
XON/XOFF (TX): On or off.
XON/XOFF (RX): On or off.
RTS/DSR Pass Through: Enabled or disabled.
Block Size: 1 to 255 characters.
Local Access: Enabled or disabled.
Status Messages: Enabled or disabled .
Serial Port Destination (multi-drop units only):
Individual ports may be assigned to communicate
with Unit 1-32, Module 1-16 and Port 1-8.
Unit Number (multi-drop units only): 1 to 32.
Composite Port: (changed in Local Unit Configuration
mode only)
Baud rate: 50, 75, 110, 135, 150, 300, 600, 1200,
2400, 4800, 9600, 19.2K, 38.4K, 57.6K, or
115.2K bps.
Line Type: Modem or Direct.
* String 1: Up to 42 characters; may be sent on the
following conditions: Power-up, loss of DCD,
manually, or by pressing the SELECT switch for
more than three seconds.
* String 2: Up to 42 characters; may be sent on the
following conditions: Power-up, loss of DCD, or
manually.
* - Applicable only when using Modem Line Type.