Owner`s manual

60
$* 
OPTION ACCESSIBILITY: Through Port 1 only.
By responding to the Enter request: message at the end of the main
configuration menu (Section 7.1) with "9" (Program I.D. Page
Message), you may program the content of this identifying message.
Note that the I.D. Page Message is a prefix for the logical name of the
device from which the data is being sent. The Model 24 will respond
with:
I.D. Page Message is :
This Print Job is for :
Enter C to change, or ENTER for no change :
If you desire to make a change, enter "C". The Model 24 will respond
with:
Enter I.D Page Message (Max. 80 characters)
Control-C to terminate or no change :
Enter the new message, followed by Control-C . Note that the message
will print on paper exactly as it is placed on the CRT screen. The
message may appear on one line or several lines. If several lines are
desired, each line must be ended by <ENTER> and Line Feed (^J).
For example, if you entered THIS IS THE NEW MESSAGE, the Model
24 will respond with:
I.D. Page Message is :THIS IS THE NEW MESSAGE
Enter C to change, or ENTER for no change :
If no change in the message is desired, strike <ENTER>, and the
current message will be retained. The Model 24 will save the new I.D.
Page Message permanently in non-volatile memory and return to the
main configuration menu (see Section 7.1).