Owner`s manual

59
You should then enter "1" if you wish to enable form feed at the
beginning of printing, "2" if you wish to disable form feed at the
beginning of printing, or strike <ENTER> if no change from the present
condition is required. For example, if you entered "1", the Model 24 will
respond with:
Form Feed at the Beginning of Printing is ( On )
Enter 1 for ON, 2 for OFF , ENTER for no change :
If no additional change is required, strike <ENTER> for no change, and
the Model 24 will respond with:
Form Feed at the End of Printing is ( Off )
Enter 1 for ON, 2 for OFF , ENTER for no change :
You should then follow the same procedure as above to enable or
disable form feed at the end of printing. For example, if you strike
<ENTER> for no change, the Model 24 will respond with:
•••••••••••••••••••••••••••••••••••••••••••••
•
Port
•
Computer
•
Form Feed
•
I.D.
•
• •
Logical Name
•
Begin
•
End
•
Page
•
•••••••••••••••••••••••••••••••••••••••••••••
•
1
•
Device A
•
On
•
Off
•
Off
•
•
3
•
Device C
•
Off
•
Off
•
Off
•
•••••••••••••••••••••••••••••••••••••••••••••
Enter Computer Port Number (ENTER = Exit) :
You may now set the form feed mode for another port, or exit by
striking <ENTER>. The Model 24 will save the new form feed settings
permanently in non-volatile memory and return to the main
configuration menu (see Section 7.1).