Owner`s manual

55
You should then enter "Y" to enable XON/XOFF on receive, "N" to
disable XON/XOFF on receive. For example, if you enter "N", the
Model 24 will respond with the reconfigured status of the port, the
option menu and the prompt:
•••••••••••••••••••••••••••••••••••••••••••••••••••
•
Port
•
Baud
•
Word
•
Stop
•
Parity
•
Xon / Xoff
•
• •
Rate
•
Size
•
Bits
• •
Xmit
•
Recv
•
•••••••••••••••••••••••••••••••••••••••••••••••••••
•
3
•
9600
•
8
•
1
•
None
•
On
•
Off
•
•••••••••••••••••••••••••••••••••••••••••••••••••••
Exit/Save......1 Set Stop Bits.....4
Set Baud Rate..2 Set Parity........5
Set Word Size..3 Set Xon/Xoff......6
Enter Request :
If there are no other changes for this port, send "1" (Exit/Save), and the
Model 24 will respond with:
Save Changes Permanently ? (Y/N) :
NOTE: When changing the configuration of the master configuration
port, Port 1, or the individual port to which you are connected, the
Model 24 will also respond with:
Change This Device to NEW Configuration
Before Answering This Request.
Save Changes Permanently ? (Y/N) :
This reminds you to make sure that the new configuration of the port
matches the configuration of the device. If they do not match, you will
be locked out of the Model 24 and unable to access its functions.
CAUTION: If "Y" is sent before changing the configuration device to the
new configuration (baud rate or parity), the Model 24 will not receive
the "Y" response. However, you will be locked out of the Model 24. To
correct this problem, recycle power on the Model 24. The unit will then
default back to the last saved configuration settings. You must then
re-enter the configuration mode, reset and resave the configuration of
the master configuration port.