Owner`s manual

54
You may now reconfigure Port 3 by selecting the appropriate option
(1-6) from the menu. For example, to change the baud rate to 2400
baud, send character "2" (Set baud rate). The Model 24 will respond
with this menu:
1 For 300
2 For 600
3 For 1200
4 For 2400
5 For 4800
6 For 9600
7 For 19200
8 For 38400
Enter Request :
Send "4" for 2400 baud rate, and the Model 24 will respond with the
reconfigured status of the port, the option menu, and the prompt:
•••••••••••••••••••••••••••••••••••••••••••••••••••
•
Port
•
Baud
•
Word
•
Stop
•
Parity
•
Xon / Xoff
•
• •
Rate
•
Size
•
Bits
• •
Xmit
•
Recv
•
•••••••••••••••••••••••••••••••••••••••••••••••••••
•
3
•
2400
•
8
•
1
•
None
•
Off
•
Off
•
•••••••••••••••••••••••••••••••••••••••••••••••••••
Exit/Save......1 Set Stop Bits.....4
Set Baud Rate..2 Set Parity........5
Set Word Size..3 Set Xon/Xoff......6
Enter Request :
You may now select other options from the menu to reconfigure Port 3.
For example, to set XON/XOFF, send character "6" (Set Xon/Xoff) in
response to the prompt. Note that Output Flow Control and Input Flow
Control are set separately for each port. The Model 24 will respond
with:
Output Flow Control (Xmit) - Xon/Xoff is ( Off )
Stop/Restart Output Upon Receiving of Xoff/Xon ? (Y/N) :
You should then enter "Y" to enable XON/XOFF on transmit, "N" to
disable XON/XOFF on transmit. For example, if you entered "Y", the
Model 24 will respond with:
Input Flow Control (Recv) - Xon/Xoff is ( Off )
Xoff/Xon sent based on Buffer - Full/Empty condition ? (Y/N) :