Owner`s manual

$



OPTION ACCESSIBILITY: Through Port 1 only.

By responding to the Enter Request: message at the end of the main

configuration menu (Section 7.1) with "4" (Program Port Select Code),

you may change the Port Select Code to a user-defined code. This

Port Select Code consists of any 1 to 8 ASCII characters. The Model

24 will respond with the following:

Port Select Code is :$SELECT

Enter Port Select Code (Max. 8 characters)

or ENTER for no change :

Enter the new Port Select Code. If less than 8 characters are entered,

you must follow entry by striking <ENTER>.

NOTE: Non-printable characters are acceptable, but they will not

appear in the Status menu.

For example, if you entered #PORT, the Model 24 will respond with:

Port Select Code is: #PORT

Enter Port Select Code (Max. 8 characters)

or ENTER for no change :

If no additional change is desired, strike <ENTER>. The Model 24 will

save the new Port Select Code permanently in non-volatile memory

and return to the main configuration menu (see Section 7.1).