Owner`s manual
44
3. Refer to the upper right hand corner of the screen for
Handshaking line status. RTS, CTS, DSR, and DTR
should all be HIGH. The DCD line is not looked at by the
terminal emulation program therefore its status can be
ignored. If these signals are not high at this point, check
to ensure the correct cable is connected.
4. Depress function key: F1.
NOTE: The F1 key in TERM sends the character
sequence
Control-T
(14 Hex) followed by the ASCII
capital C character (43 Hex).
Make sure the keyboard of your computer or terminal is in the
CAPS LOCK position.
The main configuration menu will appear as shown in
Section 7.1
.
From this point on, configuration of the Model 24 will be accomplished
by following the menus that will prompt you.