Owner`s manual

If you do not have a dumb terminal or a terminal emulation program,

BayTech supplies a utility diskette which includes software to put an

IBM PC or compatible into a terminal mode. See

Section 4.2

for

instructions to obtain the software (TERM.EXE) by running the

INSTALL.EXE program if you have not already done so.

Once you have obtained TERM.EXE, use the following procedure:

1. From the BAYTECH subdirectory prompt enter: term

The program will respond with an identification block and

configuration menu for the PC COM port similar to the

following:

You are now in the terminal emulation mode with full

duplex communication. Any characters you type from the

keyboard will be transmitted out of the PC COM port to

the Model 24. They will not appear on the CRT screen.

Any characters received from the Model 24 by the PC

COM port will be displayed on the CRT screen.

2. Ensure the displayed PC Configuration is correct. If not,

enter ALT-C to change. For example, if you have your

serial cable physically connected to COM2 on your PC,

first type ALT-C followed by the up arrow key and then

<ENTER> to have the TERM program switch to COM2.