Owner`s manual

35
For example, suppose you want to communicate with a 2400 baud
modem connected to Port 2 and your PC is connected to a computer
port set at the Model 24's factory default serial configuration (9600
baud, 8 data bit, 1 stop bit, no parity, and XON/XOFF disabled). Port 2
would need to be configured to communicate at 2400 baud to match
the baud rate of the modem. However, you would configure your
modem communications package to communicate at 9600 baud to
match the baud rate of the computer port you are connected to. You
are now ready to make the connection to the modem port through the
Model 24.
NOTE: The Model 24 does not pass hardware flow control lines
through the box. Therefore, it is suggested that you use the results
codes option on both the modem and the modem package when
communicating through the unit. Please refer to the technical
documentation on both your modem and your modem package on how
to enable and use the results codes.
IMPORTANT: Your external modem should be programmed to have
the autobaud detect feature disabled. This is done by issuing the
AT\J0 command for Hayes compatible modems.
Once you have finished your modem session, you must send the
disconnect sequence to disconnect from the modem port (see Section
6.3.1 ).