Owner`s manual

You will also need to change the serial port configuration of your PC's

com port to match that of the Model 24. If using the Model 24's factory

default serial configuration, this is accomplished via the DOS command

C:>MODE COMy: 9600, N, 8,1,P where y is the number of the

appropriate com port. This command should be part of your

AUTOEXEC.BAT file. Alternatively, you may use the SMODE.EXE

utility to operate at speeds greater than 9600 bps.

NOTE: All commands shown in bold print above and on the previous

page should be located in your AUTOEXEC.BAT file after the PATH

command and before any DOS shell commands. You should use DOS

EDLIN or EDIT to modify your AUTOEXEC.BAT file. Please refer to

your DOS documentation for instructions on EDLIN or EDIT. As an

alternative, you may use the non-document mode of a word processing

package such as Word Perfect to edit your AUTOEXEC.BAT file.

EXAMPLE: Suppose you are connecting your PC's COM1 port to the

Model 24 using factory default serial parameters and you intend to use

the RAMEXEC hot key software which has been copied to a

subdirectory call BAYTECH. Your AUTOEXEC.BAT file would need to

contain the following commands:

PATH=C:\...;C:\BAYTECH

MODE LPT1:=COM1:

MODE COM1: 9600,N,8,1,P

RAMEXEC

The vertical dots before the PATH command and after the RAMEXEC

command represent other commands that may be part of your

AUTOEXEC.BAT file. The horizontal dots shown in the PATH

command represent other subdirectories that may be part of the PATH

command.