Owner`s manual





This section provides instructions on how to set up your PC to work

with the Model 24 with respect to the BayTech software (if you intend to

use it) and special considerations when connecting your PC in serial.

If you intend to use the RAMEXEC or RAMTSR hot key programs to

select between multiple peripherals, you would typically add the

command C:>RAMEXEC or C:>RAMTSR to your PC's

AUTOEXEC.BAT file. The subdirectory created by running the

INSTALL program should be included in the PATH command. If using

the WNDEXEC program for Microsoft Windows, you should follow the

step by step instructions in the README file created by running the

INSTALL program. Please see

Section 4.2

for INSTALL instructions.

NOTE: All users that wish to use the hot key software should have a

copy of the program on their PC's hard drive. You may copy

RAMEXEC (or RAMTSR) from a PC that has already configured this

program using SETUP (or SETUPCFG) onto other PCs.

If connecting your PC to the Model 24 in serial, you would typically

reroute the parallel output to the serial port via the DOS command

C:>MODE LPTx:=COMy:, where x=1, 2, or 3 and y=1 or 2. This

command should be included in your AUTOEXEC.BAT file. If you have

a local parallel printer connected to your PC, you would not include this

command in the AUTOEXEC.BAT file. Instead, you would have your

applications software direct output to LPTx to print to the local printer or

COMy to send print jobs to the Model 24.

NOTE: If you have a local printer connected to your PC and you wish

to use RAMEXEC or RAMTSR, set up the local printer to use LPT1 and

RAMEXEC or RAMTSR to use LPT2. Then you would add the

command MODE LPT2:=COMY: to your AUTOEXEC.BAT file, where

Y = 1 or 2.