Owner`s manual
12
The Model 24 requires 115VAC, 50/60 Hz. power and comes with a
three-prong power cord. Do not attempt to operate the unit with a
two-prong socket or adapter. 230 VAC, 50/60 Hz. is optional.
The Model 24 powers up when you press the power switch on the front
of the unit to "ON". Power-on is indicated on the front panel by the
illuminating of a green LED.
CAUTION: Do not attempt to make any internal changes. Any
upgrades to the EPROM or memory must be performed by an
authorized service technician or by BayTech. Please contact BayTech
at 1-800-523-2702 for more information.
From the factory, the Model 24 Data Exchange System is set up with
Port 1 (serial) designated as a computer port. Port 1 is the master
configuration port and must always be a serial port. Port 2 is the
factory-designated printer port and also must serial. All other installed
ports are factory-designated as computer ports.
Other factory-default settings are: Input inactivity timeout is set to 20
seconds. The Port Select Code is $SELECT. The Port Select Mode is
Mode A (printer selection anytime while printing). The Form Feed
Mode and the I.D. Page Message are disabled. The Port Logical
Name(s) are set as Device A, Device B, etc. Serial ports power-up
from the factory at 9600 baud rate, 8 bit word size, 1 stop bit, no parity,
and XON/XOFF disabled.
If your application does not match the factory setup of the Model 24,
you must first reconfigure the Model 24 by entering the configuration
mode (see
Section 7
). If your application does match, you may
proceed with the installation.