Owner`s manual

CAUSE: LPTX not rerouted to COMX port for PC

serial communication.

SOLUTION: Reroute COM port as follows:

MODE LPTX:=COMY (X = 1, 2 or 3)(Y = 1, 2)

CAUSE: Model 24 is in configuration mode (all LEDs

will be illuminated).

SOLUTION: Exit configuration mode or recycle power.

SYMPTOM: PC AND PRINTER PORT LEDs ILLUMINATE,

BUT NOTHING PRINTS

CAUSE: Printer cable.

SOLUTION: Correct parallel or serial cable between

Model 24 and printer (see

Appendix A

CAUSE: Printer is off-line.

SOLUTION: Make sure printer is on-line.

CAUSE: Model 24 serial computer or printer port does

not match the configuration of the PC or printer.

SOLUTION: Enter Model 24's configuration mode and

configure the baud rate, word size, stop bits, parity

and handshaking of the computer and/or printer

port(s) to match that of the PC and/or printer.