Owner`s manual

NOTE:
If you desire a name different from the
default, you must change the name when you get to
step 6.
e. Select a file server from the
Available
list and select
[ Add <= ]
. Repeat Step 5e for each file server the
print server will service print queues for.
f. Repeat Step 5 for each BayTech print server you
wish to install.
6. If you wish to change the name, queue service interval, or
the update operation mode of the print server you have just
added, highlight the print server name in the
Print Servers
list and select
[ BayTech ]
from the "Available Print Servers"
menu. If you wish to change the serial parameters or virtual
circuit connection of a serial port on the print server,
highlight the print server name in the
Print Servers
list and
select
[ Config ]
from the "Available Print Servers" menu.
NOTE:
You may use the BCON.EXE command line utility to
change these items from a DOS prompt. Please see
Section 7.8
for more information.
7. Configure the parameters and install the peripheral ports on
the selected print server as follows:
a. Highlight the print server name in the
Print Servers
list
and select
[ Config ]
.
b. Highlight the desired peripheral in the
Printer List
.
NOTE:
The default peripheral name for Port 1 is
Printer 0
,
Printer 1
for Port 2,
Printer 2
for Port 3, and
Printer 3
for Port 4 on the PS-4A, PS-4C, and PS-4E.
The default printer name for the PS-MIO is Printer 0.
Initially, all peripheral ports will show "Not Installed".
c. You may change the various parameters and install
the highlighted printer by selecting
Configure Printer
from the "Configure Printers" menu.