Owner`s manual


BAYTECH PRINTSERVER SETUP -
[Update Mode Change]
The
[Update Mode Change]
selection in the "BayTech PrintServer
Setup" menu allows you to change the current update operation
mode of the print server. The current Update Mode is shown at the
bottom of the "BayTech PrintServer Setup" menu. If the current
mode is "Auto", this selection will respond with a "Confirm" menu
that will ask if you wish to change to manual mode. Select
[ Yes ]
if
you wish to change to manual mode. If the current mode is
"Manual", this selection will respond with an "Interval" menu for
automatic mode. If you wish to change to automatic mode, type in
the desired time interval (1 to 99 minutes), and select
[ OK ]
. The
print server will automatically update its configuration every X
minutes when set for Auto, where X is 1 to 99. The default time
interval is 15 minutes.
NOTE:
If the update operation mode is set for Manual, the only
way to update the print server of any changes made to the network
such as addition of new print queues or file servers is to select the
[Update Queue Info]
choice in the "BayTech PrintServer Setup"
menu after the changes have been made. You may use the
[Update Queue Info]
selection or cycle power on the print server
when using automatic mode if you do not wish to wait for the time
interval to expire before the print server is reconfigured.

BAYTECH PRINTSERVER SETUP -
[ Queue Service Intv ]
The
[Queue Service Interval]
selection in the "BayTech PrintServer
Setup" menu allows you to program the amount of time the print
server will check to determine if a print job is in a print queue. An
"Interval" menu will appear. You may configure this interval from 0
to 99 seconds. The default queue service interval is 4 seconds.

BAYTECH PRINTSERVER SETUP -