Owner`s manual



PRINT SERVER CONFIGURATION -

[ Configure Port ]

If you select

[ Configure Port ]

from the "Print Server Configuration"

menu, you may configure the selected printer with respect to name,

buffer size, starting form, Q change mode, type, interrupt enable,

and interrupt number. For serial ports, you may change the baud

rate, data bits, stop bits, parity and handshaking. For BayTech

print servers, you may program the port to be a printer or modem

port. The "Port Configuration" menu will appear as follows for

serial ports:

Make the desired changes and select

[ OK ]

to install the printer. The

[

Next Printer ]

selection allows you to configure the next highest printer

port. Refer to your NetWare Print Server documentation for a description

of Starting Form and Q Change Mode.

NOTE:

Any menu item with a

(+)

adjacent to it indicates a list of possible

choices may be accessed by either pressing <Space Bar> or double

clicking with the mouse. Baud rates above 9.6K are not available for all

print servers other than BayTech.

Printer Type

and

Use Interrupt

are

available on non-BayTech print servers only.