Owner`s manual


PRINT SERVER INSTALLATION USING
PCONSOLE
This section addresses setting up your BayTech print server on the
network using PCONSOLE. You should have a basic knowledge of
NetWare, particularly the PCONSOLE program. If you are
unfamiliar with NetWare, you should contact a local dealer for
installation assistance. You may use PCONSOLE or the BayTech
utility software to add the BayTech print server to your network. If
you wish to use the BayTech software, please see
Section 7
.
NOTE:
If your application requires that you change any of the
BayTech print server's default parameters (see
Section 4.6
), you
must use the BayTech software utilities. The BayTech print server
will not read any configuration changes made in PCONSOLE (i.e.,
print server name and serial parameters). If you use PCONSOLE
to add the BayTech print server to the network and assign print
queues, a quick way to change these parameters is to use the
BCON.EXE command line utility (see
Section 7.8
).
Follow the steps below to add the BayTech print server to the
network using PCONSOLE.
1. Log in as a Supervisor and run Novell PCONSOLE.
2. Create the print server as follows:
a. Highlight
Print Server Information
followed by ENTER.
b. Press INSERT and then enter the default print server
name in the "New Print Server Name" box and press
ENTER. The print server name is added to the "Print
Servers" list.
IMPORTANT:
You must initially enter the default
print server name (see
Section 4.6
). If you wish to
change the default name, you must use the BayTech
utility software after installing the BayTech print
server (see
Section 7.8
).