Owner`s manual

28
3. If you have a PS-4A or PS-4E, locate
JP5
(see the
appropriate drawing). This two-position jumper will connect
two pins furthest away from
U34
.
4. If you have a PS-4C, locate
JP6
(see the appropriate
drawing). On the PS-4C Print Server Plus, this two-position
jumper will connect two pins furthest away from
U53
. On the
PS-4C Print Server, this two-position jumper will connect two
pins furthest away from
P5
.
5. Replace the cover.
If you are installing a PS4C-TP or a PS4E-TP, proceed to
Section
5.2
. If you are installing a PS4A-TP, proceed to
Section 5.3
.

TOKEN RING CONNECTION
BayTech print server -TR models have two connectors on the rear
of the unit for interface to the Medium Access Unit (MAU). A DB-9
connector is used for shielded twisted pair connections (STP) and
an RJ-11 connector is provided for unshielded twisted pair
connections (UTP).
WARNING!!!:
Do not use both the UTP and STP connectors
simultaneously as permanent damage to the unit will result.
Refer to
Section 5.1.3.1
if you will be using STP cabling or
Section
5.1.3.2
if you will be using UTP cabling. After you have cabled the
BayTech print server to the network, if you are installing a PSMIO-
TR, proceed to
Section 6
if using PCONSOLE to add the print
server to the network or
Section 7
if using the BayTech software. If
you are installing a PS4C-TR or a PS4E-TR, proceed to
Section
5.2
. If you are installing a PS4A-TR, proceed to
Section 5.3
.