Owner`s manual

IMPORTANT:

BayTech 10BASE2 (-CX) and 10BASE-T (-TP) print

servers use a frame type of 802.3. If your network uses a frame

type other than 802.3 (e.g., Ethernet II or SNAP), you must load an

additional frame type for your network card in the file server. This

is accomplished via the LOAD command. Please refer to your

Netware System Administration documentation for more

information on loading a LAN driver more than once. You may

hardware configure the print server to support the 802.2 frame type

without the need to add another frame type to your file server. This

is done by removing the jumper at

JP2

. Once this jumper is

removed, the unit will only recognize 802.2 frames and will no

longer recognize 802.3 frames. Please see

Figure 5

on the

following page for the location of this jumper.

LED1

C47

C48

C49

JP1

Figure 5