Owner`s manual

22

FACTORY DEFAULT CONFIGURATION
The
[ Factory ]
selection under the "BayTech PrintServer Setup"
menu in PSQMGR (see
Section 7.6.7
) will reconfigure the print
server to the factory default values as follows:
*
Baud Rate:
9600 bps.
*Data bits:
8 bits.
*Stop bits:
1.
*Parity:
None.
*Handshaking:
DTR.
*Virtual circuit connection:
Printer.
Print server name:
BT-xxxxxx, where xxxxxx is the
last six hex characters of the node address. The
default name is labeled on the unit.
Operation mode:
Manual.
Queue service interval:
4 seconds.
*
- Serial ports on the PS-4C and PS-4E only.
The
[ Factory Setup ]
selection under the "Port X Modem Setup"
menu in PSQMGR (see
Section 8.2
) will reset the dial-in modem
parameters on PS-4C and PS-4E modem ports to the following
factory default values:
Modem Init String:
ATS0=1&C1^M
Prompt String:
^M^JEnter Workstation ID (Ctrl-C
to Hangup):
Answer String:
Blank
HangUp String:
~~~+++~~~ATH0^M
WkStn Init String:
blank (disabled)
Access Code:
Disabled
Timeout:
90 seconds
Nmbr of Rings:
0