Owner`s manual

Install the PS-MIO into your HP LaserJet 4 as follows:
1.
IMPORTANT:
Remove power from the printer by
positioning the on/off switch to the "0" (off) position and
unplugging the electrical cord from the AC outlet.
2. Remove any interface cables connected to the parallel or
serial ports. Next, remove the metal plate covering the MIO
slot or any existing MIO card by loosening the two
thumbscrews that secure the plate or card to the MIO slot.
You may need a flat head screw driver to initially loosen
these screws. Remove the plate or card from the MIO slot
by pulling on the two thumbscrew posts with a moderate
amount of pressure. Place the plate or card in a safe place.
3. Install the PS-MIO into the I/O slot with the 48-pin connector
towards the top of the board by sliding it along the card
guides inside the slot while holding the thumbscrew posts.
You should feel the connector on the PS-MIO card insert
into the connector inside the I/O slot. Tighten both
thumbscrews with the flat head screw driver.
4. Apply power to the printer. When the printer completes its
self test, take the printer off-line and press
Menu
key
repeatedly until "TEST MENU" appears on the display.
Press the
Item
key once and the display will show "SELF
TEST". Press the
Enter
key and the printer should print out
a
SELF TEST
page which will include information for the PS-
MIO similar to the following:
AUX IO MENU
LASERSHARE = PS
Bay Technical Associates Inc.
Version 1.00
LaserShare = PS-MIO
NAME =
XXX
ADDRESS =
YYY
This menu will confirm the installation of the PS-MIO.