Owner`s manual

20

HP LASERJET 4 AND 4SI INSTALLATION
The PS-MIO installs inside the Modular I/O (MIO) slot. Please see
Figure 4
below. You may use the existing Centronics parallel and
EIA-232/EIA-422 serial ports in addition to the ports on the PS-
MIO.
CAUTION:
The PS-MIO contains electrical components which are
susceptible to damage from static electricity. To avoid damage,
either use an anti-static wrist strap and a grounding mat similar to
those included in the Electrically Conductive Field Service
Grounding Kit (HP 9300-0933) or touch the surface of the bubble
wrap the LaserShare comes shipped in and any bare sheet metal
surface on the rear of the printer. Avoid moving about the work
area, especially if it is carpeted. Handle the PS-MIO carefully at all
times. Never flex or put excessive pressure on the card. Avoid
touching electrical components.
Figure 4: HP LaserJet Series 4 MIO Slot