Owner`s manual

The materials you will need to supply are:

Flat head screwdriver

IC DIP extractor or a pair of curved needle-nose pliers

IMPORTANT:

Remove power from the printer by positioning

the on/off switch to the "0" (off) position and removing the

AC plug from the AC outlet.

2. Disconnect the network cable from the print server and

remove the unit from the printer by first loosening the 2

thumbscrews located on the front panel with the flat head

screwdriver. Next, remove the unit from the MIO slot by

pulling on the thumbscrew posts.

3. Refer to

Appendix E.2

for the mechanical layout. With the

front of the unit facing towards you, locate socket

. The

existing EPROM will have a label on it with the model

number and firmware revision indicated.

4. Remove the existing EPROM from the socket with IC

extractor or needle-nose pliers. Gradually loosen each side

of the chip, alternating pliers from side to side, so as not to

bend chip pins. Pull loosened EPROM all the way out.

5. Install the new EPROM into the socket. The EPROM is

notched; the notch on the EPROM will point up with the

board oriented as shown in

Appendix E.2

. When installing

the new chips, be careful not to bend any of the pins. Also

make sure all pins fit their sockets.

NOTE:

If the upgrade EPROM has fewer pins than holes on

socket

, the EPROM should be installed so that there are

2 empty rows of holes closest to the notch on socket

6. Replace the cover; the upgrade is now complete.